ball mill drill press

bowlingindex: jayhawk mini jig table drill press

bowlingindex: jayhawk mini jig table drill press

The Mini Mill is a very economical choice for getting started. While very simple to operate, the Jayhawk quality is still there. This unit is built to provide many years of trouble-free operation.It uses a small milling type table giving the operator manhy of the conveniences of the larger milling machines. The machine is fully assembled in our factory saving you time during the setup process. At Jayhawk, we have proven that this is the only way to insure that your new machine is assembled and calibrated properly.

Features: X & Y table movements allow operator to provide accurate service to their customers. Operator has complete control of all pitches with easy to read scale All parts are anodized and powder coated to provde years of trouble-free operation. Minimal set up required. Machine is fully assembled and calibrated in our factory allowing you to spend more time with your customers. Bench model allows for use of minimal bench space. Complete instruction manual and a Jayhawk span rule will be included with every machine. Complete one year warranty.

This machine is not recommended for installing interchangeable devices, drilling oval holes, or cutting down ball plug. We recommend a milling machine such as the PH 3-Point or Oval Maker II for these operations.

Common Questions about the Mini Jig: I already have a drill press, can I purchase the jig only ?? Yes. The jig is easily mounted to the drill press table by 2 bolts that are provided with the jig. If using your own drill press, the spindle must have at least 5" of travel (15-1175 jig only) How much bench space does the Mini Jig need ?? The base plate on this machine is only 16" wide. For operation you should allow 24 in width and your bench should be at least 24" deep. Does the Mini Jig require much maintenance ?? The only maintenance needed is occasional lubrication to the table travel rods. This is the same that you would do with any machine with moving parts. Can I drill into an existing hole ?? Yes. You can drill into existing holes, put in slugs or grips just like the big machines, One quick note. A drill press was never designed to drill anything but straight holes. Because of this, extreme care should be used when drilling large holes. Also remember that the higher the speed you drill, the more chance for vibration. Approximately 450 RPM. On many other jigs like the Mini Jig, the tables become very sloppy in time, will this happen to the Mini Jig too ?? Anytime you have metal parts they will show wear in time. However, the Mini Jig has ajustable table slides for each table allowing the operator to tighten the slides in a matter of minutes. This will allow you to maintain the high level of accuracy that you have come to depend on from your Jayhawk Mini Jig. What if I need service for my pro shop equipment ?? Jayhawk Bowling has been in the pro shop business for more than 35 years. They been building many of its own products during this time.

jayhawk value packages

jayhawk value packages

This machine is not recommended for installing interchangeable devises, drilling oval holes, or cutting down ball plug. We recommend a milling machine such as the PH 3-Point or Oval Maker II for these operations.

Related Equipments