rock crusher craigslist

got the rock crusher finished.. - diy projects - nugget shooter forums

got the rock crusher finished.. - diy projects - nugget shooter forums

Took a couple of months, working 3 or 4 hours/day. Didin't work well on the first two iterations, but I kept at it and finally figured out what was required in the design. Not much info out there on the critical details that are required. I'll be selling plans and instructions on building this, or other jaw crushers.

I appreciate the kind words, guys. I've been wanting one of these for a few years. Noticed on the 'net, several people wondering about how to build one, or wanting plans. So, along with the other equpment plans I offer, I figured I'd tackle this and see what I could do. It does good on the relatively soft rhyolite, but we'll see in the spring how it does on harder rock. The amount of offset on the shaft determines the crushing force. More offset = less force, but faster crushing, and vis-versa. I started with 1/8" offset, and it didn't work. Then changed the toggle, still didn't work. Then, I wrongly thought it was the offset, and went to a new shaft with 1/4" offset. Still didn't work. Finally figured out the problem, and it works fine. Probably would also work fine with 1/8" offset, but would be a little slower, but would handle hard rock better. That treadmill motor would probably do hard rock better with less offset, too

Jim, yes a little bit bigger but I size mine down to 3 x 3 or smaller, I converted mine to gas from electric and couple it with my impact mill for minus 30 output. Historic screen size for the quartz / gold in the area.

Jim, yes a little bit bigger but I size mine down to 3 x 3 or smaller, I converted mine to gas from electric and couple it with my impact mill for minus 30 output. Historic screen size for the quartz / gold in the area.

Yup...I've got a fairly well-equipped shop. Lathe, mill, welders, plasma cutter, etc. The roller crusher would be tough. Need hardened rollers for that. I've thought of building a small one, but always decided I needed something else more...LOL

Jack, the very nature of jaw crushers precludes the ability to crush finer than the jaw movement. If you have any movement at all at the lower end of the jaw, the smallest size you can set the output to is equal to that movement. The problem I had with the first two attempts with mine, was too little movement at the lower end of the jaw. Mine now has about the same movement at the bottom as the top, but the timing on the movements is different. One breaks on the upstroke, and one on the downstroke. The movement is 1/4", so the smallest size I can get is 1/4" minus....maybe slightly bigger as I don't want the moving jaw to strike the fixed jaw at the bottom. It's possible to have the movement at the bottom less than the movement at the top, by varying the angle on the toggle. By making that movement less, you could get a smaller output, but at the expense of lower output rate. IMHO, as long as it crushes to <3/8" that's all that's needed before putting it in the impact crusher.

Related Equipments